2024 Process Systems Catalog

EFFICIENT DESICCANT DRYERS Requirements: • Complete Table D of the “Process Systems Incentive Catalog Supplemental Data Sheet” for this measure. • For “Hours of Operation”, enter the total hours per year the compressed air system operates. • For “Air Compressor Type,” enter “single-acting, air-cooled reciprocating,” “double-acting, water-cooled reciprocating,” “single stage, lubricant-injected rotary screw,” “two-stage, lubricant-injected rotary screw,” “lubricant-free rotary screw,” “centrifugal,” or “other.” • Must replace a heatless desiccant dryer that uses compressed air to regenerate the desiccant. • Backup and redundant desiccant dryers are not eligible. • Use the CFM value of the dryer rating when calculating the incentive amount. • Efficient desiccant dryers which also have dewpoint controls may apply for this incentive and for PS4363, provided the dryer being replaced did not have dewpoint controls or this is a new installation and there was not an existing dryer. EQUIPMENT UPGRADES AND RETROFITS Measure Description Code Incentive Unit Desiccant Compressed Air Dryer, Heated PS5441 $2 CFM Desiccant Compressed Air Dryer, Blower Purge PS5442 $2 CFM Desiccant Compressed Air Dryer, Zero Purge PS5443 $2 CFM *Supplemental Data Table needed NEW CONSTRUCTION AND MAJOR RENOVATIONS Measure Description Code Incentive Unit Desiccant Compressed Air Dryer, Heated N-PS5441 $2 CFM Desiccant Compressed Air Dryer, Blower Purge N-PS5442 $2 CFM Desiccant Compressed Air Dryer, Zero Purge N-PS5443 $2 CFM *Supplemental Data Table needed NO AIR-LOSS CONDENSATE DRAINS Requirements: • Must be used in systems with load/no-load, variable speed, variable displacement, or centrifugal compressors. • Load/no-load system must have adequate storage for drains to be eligible. • Manual drains, lever-operated mechanical drains, or solenoid drains are not eligible for incentives. • The replacement drain must be “no air-loss,” meaning it must continuously measure the presence of condensate, purge it only when necessary, and only long enough to prevent the unintentional purging of compressed air. • If no air-loss condensate drain is integral to another piece of equipment (i.e., is part of the air compressor, air dryer, mist eliminator, etc.), provide a manufacturer’s specification sheet to confirm. • Replacement of existing no air-loss condensate drains do not qualify. EQUIPMENT UPGRADES AND RETROFITS Measure Description Code Incentive Unit No Air-Loss Drain PS2254 $100 Drain NEW CONSTRUCTION AND MAJOR RENOVATIONS Measure Description Code Incentive Unit No Air-Loss Drain N-PS2254 $100 Drain PRESSURE/FLOW CONTROLLERS Requirements: • A pressure/flow controller is a device that separates the supply and demand side of a compressed air system. • Limit one controller per system. • The pressure/flow controller must be installed on the main pressure header; does not replace drop-line regulators or filter-regulator lubricators. EQUIPMENT UPGRADES AND RETROFITS Measure Description Code Incentive Unit Pressure/Flow Controller PS2255 $10 HP NEW CONSTRUCTION AND MAJOR RENOVATIONS Measure Description Code Incentive Unit Pressure/Flow Controller N-PS2255 $10 HP