2024 Lighting Catalog

INTERIOR LIGHTING HIGH AND LOW BAY FIXTURES

LED HIGH AND LOW BAY LIGHTING Requirements: • Retrofit products must be DLC SSL QPL listed (TRT V5.0 or higher) under the High-Bay or Low-Bay General Application category and be permanently wired or applicable cord and plug. • New fixtures must be DLC SSL QPL listed (TRT V5.0 or higher) under the High-Bay or Low-Bay General Application category. • Fixtures for low-bay applications may use products that are DLC SSL QPL listed (TRT V5.0 or higher) under the “Linear Ambient” General Application category, “Fuel Pump Canopy Luminaires”, or “Parking Garage Luminaires” Primary Use Designation, if they provide sufficient lighting levels and meet the wattage limitations in the table below. • Must be a 1-for-1 replacement. Incentive is per fixture replaced. • LEDs replacing existing HID fixtures less than 250W may qualify for a custom incentive. • Integral ballast screw-based lamp retrofit products are not eligible for this incentive. Refer to page 16 for High/Low-Bay Mogul Screw-base (E39) LED lamps. • ≤500W and ≤800W refers to LED total system watts and may consist of up to two fixtures replacing a single HID fixture. • Long-Day Lighting fixtures for dairy applications are eligible for this incentive. EQUIPMENT UPGRADES AND RETROFITS Measure Description Code Incentive Unit ≤155W LED, replacing 250W HID L3091 $40 Fixture ≤250W LED, replacing 320-399W HID L3092 $50 Fixture ≤250W LED, replacing 400W HID L3093 $70 Fixture ≤365W LED, replacing 400W HID L3094 $40 Fixture ≤500W LED, replacing 1000W HID L3095 $120 Fixture ≤800W LED, replacing 1000W HID L3096 $70 Fixture ≤85 Watts, Replacing 4 Lamp 4' or 2 Lamp 8' T8 or T12 L5460 $12 Fixture ≤125 Watts, Replacing 4 Lamp 4' or 2 Lamp 8' T12HO L5461 $25 Fixture ≤180W LED, replacing 6L T8 or 4L T5HO L3393 $35 Fixture ≤250W LED, replacing 8L T8 or 6L T5HO L4347 $50 Fixture ≤300W LED, replacing 10L T8 or 8L T5HO L4795 $70 Fixture ≤350W LED, replacing 12L T8 or 10L T5HO L4796 $100 Fixture General Requirements: Incentives are available for replacing or retrofitting existing high intensity discharge (HID) or linear fluorescent fixtures with permanently wired or applicable cord and plug high/low bay light emitting diode (LED) as described in each of the sections below. All products must be intended for use in high-bay or low-bay applications. New luminaires or hardwired retrofits only. Integral ballast screw-based retrofit products of any technology are not eligible for these incentives. For projects where two fixtures are installed replacing a single HID fixture, the combined wattage must be equal or less than the wattage requirements shown. Manufacturer and model number(s) are required. Product categories listed below do not imply equivalency – all installations are expected to meet current IESNA recommendations for delivered light level and uniformity. Compliance is the responsibility of the installer.